Still in the dark
12 Guide the film with your left thumb (A) and index finger and turn the take-
up core holder clockwise until the film exits on the other side of the sprocket
assembly (B). Continue to turn the take-up core holder until the film reaches
the bottom roller (C).
13 Place a core on the take-up spindle, press the center of the core holder
to lock the core in place. Fit the film end into the plastic take-up core and
wind on a few turns clockwise with the emulsion in.
14 Close the door door and make sure that it is closed securely. The
remaining steps are performed in the light.
A
B
C
To Next Page
Loading...
