ABB 2600T Series - Page 62

62
2600T SERIES | PRESSURE TRANSMITTERS | OI/266/FF-EN REV. E
...Block Mapping
Idx Parameter Description / Range / Selections / Notes
 REMOTE_SEALS_NUMBER






PRESSURE_SIMULATION_
ENABLE
0: Disabled/OFF

 PRESSURE_SIMULATION_VALUEExpressed in CAL_UNIT Pressure/dP Simulation Value to be simulated in input

STATIC_PR_SIMULATION_
ENABLE
0: Disabled/OFF


STATIC_PR_SIMULATION_
VALUE
Expressed in STATIC_P_CAL_UNIT Static Press Simulation Value to be simulated in input

SENSOR_TEMP_SIMULATION_
ENABL E
0: Disabled/OFF


SENSOR_TEMP_SIMULATION_
VALUE
Expressed in SECONDARY_VALUE_RANGE.Unit Sensor Temp Simulation Value to be simulated in input
 INTEGRATION_TIME

This parameter is available only for piezo-resistive and
capacitive sensor types
The Integration Time of the A/D converter can be changed

The accuracy of the transmitter will be higher with a high
Integration Time.
The transmitter will be faster with a short Integration
Time but the output will be more noisy depending on the
process conditions.

the input value. The end value will be reached with
expiration of the Integration Time.

transmitters with ≥

The setting of the integration time is independent from
the Damping.

calibration of the pressure measurement.