2600T SERIES | PRESSURE TRANSMITTERS | OI/266/FF-EN REV. E
61
Idx Parameter Description / Range / Selections / Notes
STATIC_P_CAL_POINT_LO Static Pressure Calibration point Low expressed in STATIC_P_CAL_UNIT
STATIC_P_CAL_MIN_SPAN Expressed in STATIC_P_CAL_UNIT.
Static Pressure Sensor Calibration minimum Span value.
When calibration is done, the two calibrated points (high
and low) must not be too close together.
STATIC_P_CAL_UNIT Static Pressure Calibration Only Pressure Units are allowed
STATIC _ P_TRIM_VALUE Static Pressure Value after the Calibration. Reference value to be adjusted with the calibration operations
DESIDERED_STATIC_P_VALUE Expressed in TERTIARY_VALUE_RANGE.Unit
Force the Measured Static Pressure to a selected Value
setting an offset between Measured and Process value.
TERTIARY_VALUE = STATIC_P_TRIM_VALUE +/-
STATIC_P_BIAS_VALUE
RESET_ STATIC_P_BIAS
TERTIARY_VALUE = STATIC_P_TRIM_VALUE
STATIC _ P_ BIAS_VALUE Expressed in TERTIARY_VALUE_RANGE.Unit
Read the offset between Measured and Process values
STATIC_P_BIAS_VALUE = STATIC_P TRIM_VALUE –
TERTIARY_VALUE
MAX_WORKING_PRESSURE Expressed in TERTIARY_VALUE_RANGE Unit Max Sensor Working Pressure
SENSOR_TEMP_CAL_POINT Expressed in SECONDARY_VALUE_RANGE.Unit
Sensor Temperature Calibration Point
An adjustment of the sensor temperature is effected by
writing the correct temperature value. This setting has no
influence to the accuracy of the pressure measurement
SET_UPPER_RANGE_POINT_PV SPAN Button emulation for Process Value
The instant measured value is written to PRIMARY_VALUE_
SET_LOWER_RANGE_POINT_PV ZERO Button emulation for Process Value.
The instant measured value is written to PRIMARY_VALUE_
PARALLEL_SHIFT_PV
The PRIMARY_VALUE_RANGE is shifted to produce the
desired percentage in output.
The PRIMARY_VALUE_RANGE span remains unchanged.
See dedicated section
MODULE_TYPE Type of Transducer technology (piezo, inductive, capacitive)
SENSOR_O_RING_MATERIAL_
HSP
Sensor O-Ring Material
High Side
PROCESS_CONNECTION_TYPE_
HSP
Process connection type
PROCESS_CONNECT_
MATERIAL_HSP
Process connection material
DRAIN_VENT_MATERIAL_HSP Drain vent Material
SENSOR_O_RING_MATERIAL_
LSP
Sensor O-Ring Material
Low Side
PROCESS_CONNECTION_TYPE_
LSP
Process connection type
PROCESS_CONNECT _
MATERIAL_LSP
Process connection material
DRAIN_VENT_MATERIAL_LSP Drain vent Material
GAUGE_ABS_PROC_CONNECT_
MTL
Process connection material for Gauge or Absolute sensor types
REMOTE_SEALS_TYPE_HSP Remote Seal type
High Side
REMOTE_SEALS_FILL_FLUID_
HSP
Remote Seal Fill Fluid
REMOTE_SEALS_ISOLATOR_
HSP
Remote Seal Isolator
REMOTE_SEALS_TYPE_LSP Remote Seal type
Low Side
REMOTE_SEALS_FILL_FLUID_
LSP
Remote Seal Fill Fluid
REMOTE_SEALS_ISOLATOR_
LSP
Remote Seal Isolator
To Next Page
Loading...
