14 Safety instructions
General safety in installation, start-up and maintenance
These instructions are for all personnel that install the drive and do maintenance work on
it.
WARNING! Obey these instructions. If you ignore
them, injury or death, or damage to the equipment
can occur.
• Secure the cabinet to the floor (see chapter
Mechanical installation) to prevent it from toppling over
when you pull out the module. The drive module is
heavy and has a high center of gravity.
• Wear protective gloves and long sleeves. Some parts
have sharp edges.
• Handle the drive module carefully:
• Use safety shoes with a metal toe cap to avoid foot injury.
• Lift the module with a lifting device only. Use the designated lifting points.
• Make sure that the module does not topple over when you move it on the floor:
Extend the support legs by pressing each leg a little down (1, 2) and turning it
aside. Whenever possible secure the module also with chains.
• Do not tilt the drive module (A). It is heavy and its center of gravity is high. The
module overturns from a sideways tilt of 5 degrees. Do not leave the module
unattended on a sloping floor.
To Next Page
Loading...
Need help?
General
