40 Mechanical installation
Note: For easy maintenance, do not install the drives on a higher level than the floor in
front of it. Otherwise the ramp supplied with the drive cannot be used when replacing the
drive modules that run on wheels.
Necessary tools
The tools required for moving the unit to its final position, fastening it to the floor and wall
and tightening the connections are listed below:
• crane, fork-lift or pallet truck (check load capacity!), iron bar, jack and rollers
• Pozidriv and Torx (2.5…6 mm) screwdrivers
• torque wrench
• set of wrenches or sockets.
To Next Page
Loading...
