ABB AV410 - View Outputs; View Hardware

10
3.2 View Outputs
Theoretical Analog Output
There are two analog outputs that are assigned automatically depending on monitor
configuration. On a single input monitor, both are assigned to Sensor A. On a dual input
monitor, Output 1 is assigned to Sensor A and Output 2 is assigned to Sensor B.
Live current output value being retransmitted.
Current output shown as a percentage of full scale for the output range set in
CONFIG.
OUTPUTS – see Section 5.5.
See Section 3.3.
See Section 4.2.
Advance to analog output 2.
3.3 View Hardware
Sensor Type A
Displays the sensor type selected for the Sensor A input in the
Factory Settings page – see
Section 7.1.
7320 100 – Low Range (0 to 20mgl
-1
C)
7320 200 – High Range (0 to 100mgl
-1
C)
Sensor Type B – Dual input monitors only
Displays the sensor type selected for the Sensor B input in the
Factory Settings page – see
Section 7.1.
Digital Communications Option Board
Note. Displayed only if the digital communications option board is fitted.
Displays the communications type enabled in the
Factory Settings page – see Section 7.1.
See Section 3.4.
See Section 4.2.
102.0
%
Analog Output 1
20.40
mA
VIEW OUTPUTS
-----
VIEW HARDWARE
SENSOR CAL
Analog Output 2
100
100
7320
Sensor Type A
VIEW HARDWARE
-----
7320
Sensor Type B
UV
UV
Digital Comms.
-----
Pb DP
VIEW SOFTWARE
SENSOR CAL
VIEW HARDWARE
…3 OPERATOR VIEWS