28
…5 PROGRAMMING
5.9 Test Outputs and Maintenance
Test Outputs
Displays the output test details for the analog outputs.
Test Output 1 frame only is shown. The format of Test Output 2 frame is identical.
Continued below.
Test Output 1
The theoretical output current value.
Output current as a percentage of the full range current.
Use the
and keys to adjust the displayed theoretical output current value to give
the output required.
Continued below.
See Section 7.1.
Advance to Test Output 2.
Maintenance
Hold Outputs
Enables the relay action and analog outputs to be maintained.
Auto. – Changes in relay action and analog outputs are disabled during sensor
calibration.
On – Changes in relay action and analog outputs are disabled.
Off – Changes in relay action and analog outputs are not disabled.
Note. The LEDs flash while the monitor is in 'Hold' mode.
Continued on next page.
See Section 7.1.
Hold Outputs set to Off or On – return to main menu.
Hold Outputs set to Auto. – continued on next page.
Test Outputs
-----
TEST/MAINTENANCE
-----
Test Output 1
4.00
mA
20.0
%
Maintenance
-----
Hold Outputs
-----
Auto.
On
Off
FACTORY SETTINGS
Test Output 2
FACTORY SETTINGS
Sensor A Outputs
Maintenance
Maintenance
Automatic Time
Maintenance
To Next Page
Loading...
