AWT420 | UNIVERSAL 4-WIRE, DUAL-INPUT TRANSMITTER | OI/AWT420-EN REV. B
37
Calibrate
Used to calibrate the sensor.
Note. Calibrate Calibration section (page 55) for
specific routines.
Access to the Calibrate menu is permitted via the Calibrate and Advanced levels or directly from
an Operator page using the Cal button.
Menu
Comment Default
S1: <Sensor Type> Note.
S1: <Sensor Tag> )
for specific routines.
S2: <Sensor Type> Note.
S2: <Sensor Tag> )
for specific routines.
pH Buffers NoteMeasurement Type
Buffer 1
• Supported buffer solutions from table below/user-defined.
Used Buffer 1 Note.
Set the user defined buffer characteristic curve using the five point linearizer table
N/A
Buffer 2
• Supported buffer solutions from table below/user-defined.
Used Buffer 2 Note.
Set the user defined buffer characteristic curve using the five point linearizer table
N/A
Hold Outputs Set to automatically hold current outputs and alarms whilst a calibration is being performed.
• Disabled/Enabled.
Buffer solutions
AWR126B026EN
AWR126B027EN
3KXA163000L0201
AWR126B028EN
AWR126B011EN
AWR126B013EN
AWR126B015EN
AWR126B017EN
AWR126B018EN
AWR126B019EN
AWR126B020EN
AWR126B021EN
AWR126B022EN
AWR126B023EN
AWR126B024EN
3KXA163000L0202
AWR126B025EN
0400/110
0400/120
0400/130
Calibrate
Exit
Menu
Select
To Next Page
Loading...
