ABB AWT420 - Sensor Setup; Device Setup

38
AWT420 | UNIVERSAL 4-WIRE, DUAL-INPUT TRANSMITTER | OI/AWT420-EN REV. B
… 13 Configuration (Advanced access level)
Sensor Setup
Used to access standard setup parameters.
Note. Sensor Setup Calibration section (page 55)
and relevant sensor manual for full details of sensor setup.
Menu
Comment Default
S1: <Sensor Type> Note. 
S1: <Sensor Tag> Sensor setup section (page <?>).
S2: <Sensor Type> Note. 
S2: <Sensor Tag> Sensor setup section (page <?>).
Hold Outputs Note. 
Access the Calculated Values specific setup pages, refer to the Sensor setup section (page <?>).
Device Setup
Used to access standard setup parameters.
Menu
Comment Default
Initial Setup
Instrument Tag Enter an alphanumeric transmitter identification tag


Temperature Units Select the units in which all temperatures are displayed:
• °C/°F

Security Setup
Calibrate Password Set the password to enable access at Calibrate level. Not factory-set
Advanced Password Available only at Advanced access level. Not factory-set
Service Access
Service Password Reserved for use by authorized ABB service technicians Set at factory
Write Protection
Restore Defaults Select to restore ALL transmitter configuration parameters to their default values and restart the transmitter.
Sensor Setup
Exit
Menu
Select
Device Setup
Exit
Menu
Select