ABB COM600 Station Automation Series - Default Chapter; Table of Contents

Contents:
1. About this manual .................................................................................. 7
1.1. Copyrights ...................................................................................... 7
1.2. Trademarks .................................................................................... 7
1.3. General .......................................................................................... 7
1.4. Document conventions .................................................................. 8
1.5. Use of symbols .............................................................................. 9
1.6. Terminology .................................................................................... 9
1.7. Abbreviations ............................................................................... 11
1.8. Related documents ...................................................................... 12
1.9. Document revisions ..................................................................... 12
2. Introduction ........................................................................................... 13
2.1. Product overview ......................................................................... 13
2.2. DNP 3.0 OPC Server features ..................................................... 13
3. Configuration ........................................................................................ 18
3.1. About this section ......................................................................... 18
3.2. Overview of configuration ............................................................ 18
3.3. Building object tree ...................................................................... 19
3.3.1. General about building object tree ................................ 19
3.3.2. Adding Gateway object ................................................. 19
3.3.3. Adding DNP OPC Server object ................................... 19
3.3.4. Adding DNP Channel objects ....................................... 20
3.3.5. Adding DNP IED objects ............................................... 20
3.3.6. Adding Logical Device objects ...................................... 21
3.3.7. Adding Logical Node objects ........................................ 21
3.3.8. Adding data objects ...................................................... 21
3.4. Configuring objects ...................................................................... 22
3.4.1. General about configuring objects ................................ 22
3.4.2. Configuring DNP OPC Server properties ...................... 23
3.4.3. Configuring DNP OPC Server LAN Channel
properties ...................................................................... 23
3.4.4. Configuring DNP LAN Device ....................................... 24
3.4.5. Configuring Logical Device properties .......................... 26
3.4.6. Configuring Logical Node properties ............................. 27
3.4.7. Configuring data objects for internal OPC data ............ 27
3.4.7.1. General about configuring data objects for
Internal OPC Data ...................................... 27
3.4.7.2. Integer status (INS) ................................... 28
3.4.7.3. Controllable single point (SPC) for OPC
internal data ................................................ 28
3.4.7.4. Single point status (SPS) ........................... 29
3.4.8. Configuring data objects ............................................... 30
3.4.8.1. General about configuring data objects ...... 30
3
DNP 3.0
LAN/WAN Master
(OPC) 3.2
COM600 Station Automation Series1MRS756566
User's Guide
Issued: 17.06.2008
Version: A/17.06.2008