Set the controller Name, Device Instance Number and IP Address : Port (for exporting to ASPECT® and INTEGRA™)
and if the FBXi device has one or more FLX modules connected to it, add the same number of entries in the
Modules table:
When FLX modules have been added, the specific FLX type can be set in the Modules table Type column:
If you attempt to add more modules than the FBXi can support, an error message will be displayed:
When the correct number of FLX modules has been added, click OK.
Note: The IO module configuration can be changed later by opening the FLX Module Configuration dialog from the
Site Tree:
To Next Page
Loading...
