12 DPA 250 S4 50-250 KW OPERATING MANUAL
WARNING
THIS IS A PRODUCT FOR INDUSTRIAL
APPLICATION IN THE SECOND
ENVIRONMENT AS DEFINED IN IEC/EN
RESTRICTIONS OR ADDITIONAL
MEASURES MAY BE NEEDED TO PREVENT
DISTURBANCES
The UPS must be installed according to the rec-
ommendations in this manual. To operate the UPS
at peak efficiency, your installation site should
satisfy the environmental parameters outlined in
this manual. Excessive amount of dust in the op-
erating environment of UPS may cause damage or
lead to malfunction. The UPS should be always
protected from the outside weather and sun-
shine. If you intend to operate the system at an al-
titude higher than 1000 meters above sea level,
contact your local sales or service office for im-
portant information about high altitude opera-
tion. The operating environment must meet the
weight, airflow, size and clearance requirements
specified in the technical datasheet.
The basic environmental requirements of the UPS
system are:
Ambient Temperature Range
Recommended Operating Range
Maximum Relative Humidity
The UPS cabinet uses forced air cooling to regu-
late the internal temperature of components. Air
inlets are located at the front of the cabinet, and
outlets at the top of the cabinet. You must allow
clearance on the top of the cabinet for proper air
circulation. Refer to the chapter "9.2 UPS loca-
tion".
—
2 General information
The product has the EC marking in compliance
with the following European directives:
• Low Voltage Directive: 2014/35/EC
• EMC Directive: 2004/30/EC
Further ABB UPS systems are in compliance with
following standards:
Product Standards Standards
Safety Standard
Electromagnetic Compatibility
Standard (EMC)
Performance Standard
—
2.1
Declaration of safety compliance and EC marking
The primary function of the ABB UPS covered by
the above standards is to ensure continuity of an
AC power source. The UPS may also be used to
improve the quality of the power source by keep-
ing it within specified characteristics. The UPS
has been developed over a wide range of power
ranges, from 50kW to 1.25MW to satisfy require-
ments for availability and quality of power to vari-
ety of IT equipment and devices.
Furthermore, the ABB manufacturer is certified
successfully in every area according to the model
of the International Standard:
ISO 9001/EN 29001. Certification of the UPS with
the operating performance according to the stan-
dard IEC 62040-3 and VDE 0558 Part 530 is ac-
complished.
To Next Page
Loading...
