EL3000 CONTINUOUS GAS ANALYZERS | OI/EL3000-EN REV. D 129
Test gases – Limas23
Test gas for the zero calibration
Test gas for the end-point calibration
with calibration cells
2
or air or UV sample component-free gas
Calibration cells or test gas for each sample
component
without calibration cells
2
or air or UV sample component-free gas
Test gas for each sample component
without calibration cells
2
or air or UV sample component-free gas
Test gas for each sample compo
nent
/ Magnos28 or oxygen
with calibration cells
(automatic calibration, i.e. Magnos206
/ Magnos28
with single-point calibration)
2
or oxygen and UV sample component-free gas
Either calibration cells and test gas for
oxygen
detector or test gas for each sample component or
for each detector
/ Magnos28 or oxygen
without calibration cells
2
or oxygen and UV sample component-free gas
Test gas for each sample component o
r for each
/ Magnos28 or oxygen
without calibration cells
2
or oxygen and UV sample component-free gas
Test gas for each sample component or for each
detector
Dew point
The dew point of the test gases must be approximately equal to the dew point of the sample gas.
To Next Page
Loading...
