EL3000 CONTINUOUS GAS ANALYZERS | OI/EL3000-EN REV. D 201
Packing the Gas Analyzer
1. Remove adapters from the gas ports and tightly seal the gas
ports.
2. If the original packaging is not available, wrap the gas
analyzer in bubble wrap or corrugated cardboard. For
overseas shipment, always add a desiccant (e.g., silica gel)
and hermetically seal the gas analyzer plus desiccant in a
layer of polythene that is 0.2 mm thick. The amount of drying
agent should be appropriate for the package volume and the
expected shipping duration (at least 3 months).
3. Pack the gas analyzer in an adequately sized box lined with
shock-absorbing material (foam or similar). The thickness of
the shock-absorbing material should be adequate for the
weight of the gas analyzer and the mode of dispatch. When
shipping overseas, additionally line the box with a double
layer of bitumen paper.
4. Mark the box as "Fragile Goods".
Note
If the device is returned to ABB Service (e.g. for repair), the
following points must be observed:
• It is essential that the gases that were introduced into
the gas analyzer are specified on the return form (see
Return form on page 213).
• See the information in Returning devices on page 176!
Transport-/Storage temperature
−25 to 65 °C
To Next Page
Loading...
