ABB i-bus KNX

ABB i-bus
®
KNX
Commissioning
FCA/S 1.x.x.1 | 2CDC508134D0202 137
3.2.3.11 Parameter window Automatic control (Multi-level)
This parameter window is visible if the option Yes has been selected with the parameter Enable automatic
operation in Parameter window E, F, G: Fan (Multi-level), p. 124.
The limits can be enabled in this parameter window.
Object value "Automatic On/Off"
switch on to the automatic
Options:
1
0
This parameter defines how the device should react to a telegram.
 1: Automatic is activated by a telegram with value 1.
 0: Automatic is activated by a telegram with value 0.