ABB i-bus KNX - Parameter Window Manual Operation - Settings

ABB i-bus
®
KNX
Commissioning
72 2CDC508134D0202 | FCA/S 1.x.x.1
3.2.2 Parameter window Manual operation – Settings
Note
This parameter window is only visible for devices with manual operation.
Settings for manual operation:
Manual operation
Options:
Disabled
Enabled
Enable/disable via comm. object
This parameter defines if the switchover between the operating states Manual operation and KNX
operation is possible via the button on the device or via a communication object.
For further information see: Manual operation, p. 61
Note
The manual operation overwrites the input states.