ABB i-bus KNX

ABB i-bus
®
KNX
Commissioning
68 2CDC508134D0202 | FCA/S 1.x.x.1
3.2 Parameters
The ETS Engineering Tool Software is used to parameterize the device.
The application appears in ETS in the Catalogs window under Manufacturers/ABB/Heating, Ventilation/
Fan Coil Actuator single.
The following chapters describe the device parameters using the parameter windows. Parameter windows
are structured dynamically so that further parameters may be enabled depending on the parameterization
and function of the outputs.
The default values of the parameters are underlined, e.g.:
Options:
Yes
No
Note
For screen shots, the application of the FCA/S 1.1.2.2 (with PWM and manual operation) is used
representatively for all devices.