ABB i-bus KNX

ABB i-bus
®
KNX
Commissioning
FCA/S 1.x.x.1 | 2CDC508134D0202 113
3.2.3.5 Parameter window Function
In this parameter window, various functions for each output can be activated. The functions are identical
for the operation modes Valve drive, thermoelectric (PWM), Valve drive, motor-driven (3-point) and Valve
drive, analog (0...10 V).
Enable function "Priority and safety
operation"
Options:
No
Yes
 Yes: The Parameter window Security, p. 117, is enabled.
Enable communication object
"Status Control value" 1-bit/byte
Options:
No
Yes
This parameter enables the communication object Status Control value. The control status of the output is
sent via this communication object.
 Yes: The communication object Status Control value, p. 212, is enabled.
Dependent parameters: