ABB i-bus KNX - Parameter Window Automatic Control (One-Level)

ABB i-bus
®
KNX
Commissioning
156 2CDC508134D0202 | FCA/S 1.x.x.1
3.2.3.18 Parameter window Automatic control (One-level)
This parameter window is visible if the option Yes has been selected under the parameter Enable
automatic operation in Parameter window E, F, G: Fan (One-level), p. 149.
This is the parameter window where you define the threshold values for switchover of the fan speed. You
can also enable limitations here.
Object value "Automatic On/Off"
switch on to the automatic
Options:
1
0
This parameter defines how the device should react to a telegram.
 1: Automatic is activated by a telegram with value 1.
 0: Automatic is activated by a telegram with value 0.