ABB i-bus KNX

ABB i-bus
®
KNX
Commissioning
184 2CDC508134D0202 | FCA/S 1.x.x.1
3.2.4.3.1 Parameter Distinction between long and short operation – No
If the option No has been selected with the parameter Distinction between long and short operation, the
following parameters appear in Parameter window a: Value/forced operation, p. 181:
Opening the contact -> Event 0
Closing the contact -> Event 1
<−−− NOTE
Activate minimum signal duration
Options:
No
Yes
Selection Yes:
Dependent parameters:
On closing the contact
in [0...65,535] X 0.1 s
Options:
0…10…65,535
On opening the contact
in [0…65,535] x 0.1 s
Options:
0…10…65,535