ABB i-bus KNX - Parameter Window Status Messages (Multi-Level)

ABB i-bus
®
KNX
Commissioning
FCA/S 1.x.x.1 | 2CDC508134D0202 129
3.2.3.9 Parameter window Status messages (Multi-level)
This is the parameter window where status messages are defined.
Enable communication object
"Status Fan speed x" 1-bit
Options:
No
Yes
The setting of a fan speed is displayed via these communication objects. You can parameterize whether or
not the status of a current or required fan speed is displayed.
 Yes: Three 1 bit communication objects, Status Fan speed x (x = 1...3) are enabled.
Dependent parameters:
Meaning
Options:
Current fan speed
Required fan speed
This parameter defines which status – Current fan speed or Required fan speed – is displayed.