ABB i-bus KNX - Page 161

ABB i-bus
®
KNX
Commissioning
FCA/S 1.x.x.1 | 2CDC508134D0202 159
Reset time for automatic operation
in s [1...65,535], 0 = inactive
Options:
0
1…65,535
This parameter determines after which time the automatic operation is reset.
 0: If 0 is selected, automatic operation is not reset.
 1...65,535: If a time from a value of 1 is set, automatic operation is reset after the given time.
Note
A change of the parameter value will only become active after the next deactivation of automatic
operation by a direct communication object.