4 Repair
4.4.1. Replacement of shaft and bearings, tilthouse
3HAC026048-001 Revision: A104
© Copyright 2006-2008 ABB. All rights reserved.
Dismounting tool, tilthouse shaft
The tool for removing the tilthouse shaft from the tilthouse is assembled with the parts shown
in the figure below (included in the toolkit for service).
Note! The parts cannot be ordered separately, but are included in the complete toolkit! The
article numbers are only given for identification.
xx0600002589
A Hydraulic cylinder, 3HAC11731-1
B Press washer, 3HAC023963-007
C Hex socket head cap screw, 9ADA183-25, 2 pcs, M6 x 25
D Connection rod, M16, length= 400 mm
E Nut, 3HAC5507-1
F Sleeve, 3HAC023963-027
G Nut, 3HAC023963-028
J Pad, 3HAC023963-029
Continued
Continues on next page
To Next Page
Loading...
