4 Repair
4.4.1. Replacement of shaft and bearings, tilthouse
3HAC026048-001 Revision: A106
© Copyright 2006-2008 ABB. All rights reserved.
Mounting tool, tilthouse shaft
The tool for fitting the tilthouse shaft to the tilthouse is assembled with the parts shown in the
figure below (included in the toolkit for service).
Note! The parts cannot be ordered separately, but are included in the complete toolkit! The
article numbers are given only for identification.
xx0500002581
B Press washer, 3HAC023963-007
C Hex socket head cap screw, 9ADA183-25, 2 pcs, M6 x 25
D Connection rod, M16, length= 400 mm
E Nut, 3HAC5507-1
G Nut, 3HAC023963-028
M Sleeve, 3HAC023963-037
A Hydraulic cylinder, 3HAC11731-1
B Press washer, 3HAC023963-007
C Hex socket head cap screw, 9ADA183-25, 2 pcs, M6 x 25
D Connection rod, M16, length= 400 mm
E Nut, 3HAC5507-1
J Pad, 3HAC023963-029
K Press washer, 3HAC023963-014
Continued
Continues on next page
To Next Page
Loading...
