Electrical installation: AC input, motor and brake 43
Electrical installation:
AC input, motor and brake
What this chapter contains
The chapter describes how to connect input power cables, motor and brake resistor.
WARNING! The work described in this chapter may only be carried out by a
qualified electrician. Follow the instructions in chapter Safety on page 11.
Ignoring the safety instructions can cause injury or death.
Make sure that the drive is disconnected from the input power during
installation. If the drive is already connected to the input power, wait for 5
minutes after disconnecting the input power.
See the requirements in Electrical power network specification on page 129. Use a
fixed connection to the AC power line.
To Next Page
Loading...
