ABB PT003901 - Figures

Operation Manual / Power2 340-H / High-pressure stage
Figures
© Copyright 2022 ABB. All rights reserved. HZTL4054_EN Revision F March 2022
Figures
Fig.1: Layout and function ............................................ 7
Fig.2: Layout of the high-pressure stage ................. 8
Fig.3: Function of the high-pressure stage.............. 9
Fig.4: Volatile Corrosion Inhibitor (VCI)................... 12
Fig.5: Package with hygrometer................................ 13
Fig.6 High-pressure stage ........................................... 18
Fig.7: Rating plate ........................................................ 19
Fig.8: Location of Power2 HP rating plate ............. 20
Fig.9: Attachment of loads on the crane hook ....... 21
Fig.10: Attachment angle............................................ 21
Fig.11: Swivel lifting eye (example) .......................... 30
Fig.12: Transport.......................................................... 30
Fig.13: Removing the high-pressure stage.............. 31
Fig.14: Loosening the clamping nut ......................... 32
Fig.15: Removing the high-pressure stage.............. 33
Fig.16: Gaskets in the slots of the bearing casing 34
Fig.17: Preparing the fastening elements of the
high-pressure stage..................................................... 35
Fig.18: Placing the high-pressure stage on the
bracket ........................................................................... 36
Fig.19: Steps for fastening the high-pressure stage .
37
Fig.20: Steps for fastening the high-pressure stage.
38
Fig.21: Preparing the clamping nut for the tighten-
ing procedure ............................................................... 39
Fig.22: Tightening pressure screws......................... 40
Fig.23: Oil monitoring................................................. 45
Fig.24: Overview: speed measurement on high-
pressure stage .............................................................. 47
Fig.25: Noise insulation, bellows............................... 51
Fig.26: Bellows ............................................................. 60
Fig.27: Swivel lifting eye (example)........................... 71
Fig.28: Weights of the assemblies............................ 72
Fig.29: Removing the gas outlet casing................... 73
Fig.30: Removing the air inlets ................................. 74
Fig.31: Removing the compressor casing................ 75
Fig.32: Removing the cartridge group...................... 77
Fig.33: Removing the gas outlet flange / nozzle ring.
78
Fig.34: Nozzle ring compression PD ......................... 79
Fig.35: Installing the gas outlet flange / nozzle ring..
80
Fig.36: Installing the cartridge group....................... 81
Fig.37: Installing the compressor casing ................. 82
Fig.38: Installing the air inlet...................................... 83
Fig.39: Installing the gas outlet casing .................... 84
Fig.40: Measuring clearances N and R...................... 85
Fig.41: Measuring clearance A and B......................... 86
Fig.42: Overview of tightening torques ................... 87
Fig.43: Attaching a cover plate .................................. 90
Fig.44: Cover plate drawing ....................................... 91
Fig.45: Figure for cover plate, slots for O-rings ..... 92
Page 112 / 114Page 112 / 114