Additional informationTask
Cleaning the air filters
Clean the air filters by blowing compressed air
from the inside to the outside through the filter
until the dust comes off.
Loosen and remove the screws on the filter frame.
Clean the grill interior with a vacuum cleaner.
Install the filter support frames and tighten the
screws.
Cleaning the fans
Prevent the circuit breaker from turning on acci-
dentally.
Turn OFF/OPEN the circuit breaker for fan.
Measure to make sure that it is not energized.Disconnect the supply and signal cabling.
Use compressed air to clean the fans.
Cleaning the MV switchgear area
If necessary, use a duster or pressurized air to
clean locations you cannot reach with the vacuum
cleaner.
Use a vacuum cleaner to clean the floor, doors
and interior metal beams.
Maintenance of painted surfaces
WARNING!
Obey the Safety instructions (page 9) and the local safety regulations. If ignored,
physical injury or death, or damage to the equipment may occur.
WARNING!
Obey the Safety instructions (page 9), requirements and specifications of the
primer and paint manufacture.
￭ Repainting the scratched areas
Tools and materials
Use the following tools and materials. If the listed tools are not available in your local market,
you can use products with similar characteristics approved by a qualified technician, and
get approval from ABB.
MakeSpecificationTool
Silver P80 Triton1 udFlap Disc
Bosch1 udGrinding machine
Ehs10 udFlexible abrasive sponges
-250 mlDegreasing sprays
Finissage, Impa1 udBody shop putties
-200 grRags or blower
-10 udDisposable gloves
Uvex Astrospec1 udSafety glasses
Maintenance 57
To Next Page
Loading...
Need help?
General