ABB RED650 - Page 12

Identification.............................................................................. 210
Application................................................................................. 210
Setting guidelines...................................................................... 211
General.................................................................................211
Setting of common parameters............................................ 211
Negative sequence based....................................................212
Zero sequence based...........................................................213
Delta U and delta I ...............................................................213
Dead line detection...............................................................214
Section 12 Control..........................................................................215
Synchrocheck, energizing check, and synchronizing SESRSYN...215
Identification.............................................................................. 215
Application................................................................................. 215
Synchronizing.......................................................................215
Synchrocheck.......................................................................217
Energizing check.................................................................. 218
Voltage selection.................................................................. 219
External fuse failure..............................................................220
Application examples.................................................................221
Single circuit breaker with single busbar.............................. 222
Single circuit breaker with double busbar, external
voltage selection...................................................................223
Single circuit breaker with double busbar, internal
voltage selection...................................................................223
Setting guidelines...................................................................... 224
Autorecloser for 1 phase, 2 phase and/or 3 phase operation
SMBRREC .....................................................................................229
Identification.............................................................................. 229
Application................................................................................. 229
Auto reclosing operation Off and On.................................... 233
Start auto reclosing and conditions for start of a
reclosing cycle......................................................................233
Start auto reclosing from circuit breaker open information...234
Blocking of the auto recloser................................................ 234
Control of the auto reclosing dead time for shot 1................234
Long trip signal..................................................................... 235
Maximum number of reclosing shots....................................235
ARMode = 3ph, (normal setting for a three-phase shot)...... 235
ARMode = 1/2/3ph ............................................................... 235
ARMode = 1/2ph , 1-phase or 2-phase reclosing in the
first shot................................................................................236
ARMode = 1ph+1*2ph, 1-phase or 2-phase reclosing in
the first shot..........................................................................236
Table of contents
6 Line differential protection RED650 2.2 IEC
Application manual