protocols, and to the section 103, Companion standard for the informative interface
of protection equipment.
18.6.1.2 Design
M17109-41 v1
General
M17109-43 v2
The protocol implementation consists of the following functions:
• Event handling
• Report of analog service values (measurands)
• Fault location
• Command handling
• Autorecloser ON/OFF
• Teleprotection ON/OFF
• Protection ON/OFF
• LED reset
• Characteristics 1 - 4 (Setting groups)
• File transfer (disturbance files)
• Time synchronization
Hardware
M17109-59 v2
When communicating locally with a Personal Computer (PC) or a Remote
Terminal Unit (RTU) in the station, using the SPA/IEC port, the only hardware
needed is:· Optical fibers, glass/plastic· Opto/electrical converter for the PC/RTU·
PC/RTU
Commands
M17109-62 v4
The commands defined in the IEC 60870-5-103 protocol are represented in
dedicated function blocks. These blocks have output signals for all available
commands according to the protocol. For more information, refer to the
Communication protocol manual, IEC 60870-5-103.
• IED commands in control direction
Function block with defined IED functions in control direction, I103IEDCMD.
This block use PARAMETR as FUNCTION TYPE, and INFORMATION
NUMBER parameter is defined for each output signal.
• Function commands in control direction
Function block with pre-defined functions in control direction, I103CMD. This
block includes the FUNCTION TYPE parameter, and the INFORMATION
NUMBER parameter is defined for each output signal.
• Function commands in control direction
1MRK 505 393-UEN B Section 18
Station communication
Line differential protection RED650 2.2 IEC 385
Application manual
To Next Page
Loading...
Need help?
General
