ABB RER615 - Page 63

<45>:= Single command C_SC_NA_1
<46>:= Double command C_DC_NA_1
<47>:= Regulating step command C_RC_NA_1
<48>:= Set point command, normalized value C_SE_NA_1
<49>:= Set point command, scaled value C_SE_NB_1
<50>:= Set point command, short floating point value C_SE_NC_1
<51> := Bitstring of 32 bit C_BO_NA_1
System information in monitor direction
(Station-specific parameter, mark with an “X“ if it is only used in the standard
direction, “R“ if only used in the reverse direction, and “B“ if used in both directions.)
<70> := End of initialization M_EI_NA_1
System information in control direction
(Station-specific parameter, mark each Type ID with an “X“ if it is only used in the
standard direction, “R“ if only used in the reverse direction, and “B“ if used in both
directions.)
<100>:= Interrogation command
C_IC_NA_1
<101>:= Counter interrogation command C_CI_NA_1
<102>:= Read command C_RD_NA_1
<103>:= Clock synchronization command (option see 7.6) C_CS_NA_1
<104>:= Test command C_TS_NA_1
<105>:= Reset process command C_RP_NA_1
<106>:= Delay acquisition command C_CD_NA_1
Parameter in control direction
(Station-specific parameter, mark each Type ID with an “X“ if it is only used in the
standard direction, “R“ if only used in the reverse direction, and “B“ if used in both
directions.)
1MRS757824 C Section 3
IEC 60870-5-101/104 protocol implementation
Recloser Protection and Control RER615 57
Point List Manual