ABB RER615 - Page 64

<110>:= Parameter of measured value, normalized value P_ME_NA_1
<111>:= Parameter of measured value, scaled value P_ME_NB_1
<112>:= Parameter of measured value, short floating point value P_ME_NC_1
<113>:= Parameter activation P_AC_NA_1
File transfer
(Station-specific parameter, mark each Type ID with an “X“ if it is only used in the
standard direction, “R“ if only used in the reverse direction, and “B“ if used in both
directions.)
<120>:= File ready F_FR_NA_1
<121>:= Section ready F_SR_NA_1
<122>:= Call directory, select file, call file, call section F_SC_NA_1
<123>:= Last section, last segment F_LS_NA_1
<124>:= Ack file, ack section F_AF_NA_1
<125>:= Segment F_SG_NA_1
<126>:= Directory {blank or X, only available in monitor (standard) direction} F_DR_TA_1
Type identifier and cause of transmission assignments
(Station-specific parameters)
Shaded boxes: option not required.
Blank: functions or ASDU not used.
Mark the Type Identification/cause of transmission combinations.
"X" if only used in the standard direction
"R" if only used in the reverse direction
"B" if used in both directions
Section 3 1MRS757824 C
IEC 60870-5-101/104 protocol implementation
58 Recloser Protection and Control RER615
Point List Manual