ABB SCK - Maintenance Plan Overview

150 System Manual SCK Gas Sampling System 42/23-81 EN Rev. 4
Maintenance task See … Inspection/Maintenance
intervall
as required
dayiy
weekly
twice yearly
yearly
every 2 years
Gas sampling probe 60S
 Mechanical cleaning of probe
pipe and tip
Gas sampling probe 60S: Removing
incrustations on page 182
X X
 Clean or replace outlet filter
Gas sampling probe 60S: Cleaning or
replacing the outlet filter on page 184
X X
 Replace O-ring seals on the
filter unit
Gas sampling probe 60S: Replacing the
seal set on page 187
X
Maintenance task See … Inspection/Maintenance
intervall
as required
dayiy
weekly
twice yearly
yearly
every 2 years
Probe retractor
 Check filter muffler
Probe retractor: Checking and replacing
the filter muffler on page 191
X
 Check oil level in oiler in
pneumatic box and changing
the quantity of oil delivered
Probe retractor: Checking and topping up
the oiler on page 193
X
 Check and if necessary tight-
en drive chain
Probe retractor: Checking and tightening
the drive chain on page 196
X X
 Check and if necessary
adjust the filter/pressure con-
trol combination or replace fil-
ter
Probe retractor: Checking filter/pressure
control combination on page 189
X
 Check condition of bellows
Probe retractor: Checking the bellows on
page 205
X
 Check and, if necessary,
adjust the position of the
probe
Probe retractor: Checking and, if neces-
sary, adjusting the position of the probe
on page 198
X
 Check position indicator on
the retractor and, if neces-
sary, re-align
Probe retractor: Checking and, if neces-
sary, adjusting the position indicator
(probe end position) on page 202
X X