ABB SCK System Manual

174 System Manual SCK Gas Sampling System 42/23-81 EN Rev. 4
Gas sampling probe H: Removing incrustations
 daily (or as required)
Always take the following safety measures when performing this work:
 Wear a face mask against heat, heat-proof gloves and protective welder's cloth-
ing.
 Turn the service switch to ON and secure the service switch against unauthor-
ized switching (with a padlock).
 Additionally press the EMERGENCY STOP switch.
 Do not enter the danger area around the retractor until it is at standstill and the
warning lamps and buzzer are off and the shutter is closed.
 Do not perform the work until the gas sampling system has cooled down.
 Lock the shutter when you start the work, unlock the shutter after finishing the
work.
 Always keep the floor around the gas sampling system clean and dry.
Explanation of safety measures: Safety regulations for maintenance work on page
156.
 Chisel
 Hammer
Maintenance interval
Safety
measures
Tools required

ABB SCK Specifications

General

Brand	ABB
Model	SCK
Category	Industrial Equipment
Language	English