ABB SF6 LTB 245E1 BLG 1002A - Page 48

Assembly Assembly Instructions
22
1HSB435410-2 enrev1
• Lock the pull-rod using the locking nuts (1) when the alignment check hole (2)
aligns with the corresponding alignment check hole in the mechanism housing.
Tighten the locking nuts with a tightening torque of 300 Nm.
Figure 4-16. Alignment check hole.
4.9.4 Assembling the pull-rod between poles B1 and C1
Assemble the pull-rods between poles B1 and C1 in the same way.
Item
1 Locking nuts
2 Alignment check
hole
2
1
B10135
TIGHTENING TORQUE
300 Nm