ABB UMC100.3 - Page 125

Parameter
Number
Parameter Description, Explanations Options Adjustable
via
Invert control (ctrl) Inputs
  

 All
  



adjusted in a wide range.

   


All


 
reset can be enabled.
,







message can be defined which is shown on the


characters each.


Panel




 
NC: Normally closed
NO: Normally open

Motor running or stopped

Always when the motor is running





























All
Extended
 Checkback time 
was closed until the checkback signal is present








 Emergency Start To allow start-ups even if the thermal overload
protection would prevent them.
 All
 Fault auto reset Automatically reset of selected protection faults


inputs and the IO module are not automatically
reset. There are separate parameters.
 All
 Custom app parameter Allows to specify a value which is available in the
custom application.
 All
  
fieldbus
 

  
fieldbus
 

  
fieldbus
 

  
fieldbus
 

  
fieldbus
 

Motor Management Parameters Continued
125
PARAMETERS AND DATA STRUCTURES ON A FIELDBUS