Communication Parameters
Parameter
Number
Parameter
Name
Description, Explanations Options Adjustable via
Address check Enable check if bus address stored in the UMC is the same as the
one stored in the communication interface.
All
Busfault
reaction
UMC behaviour in the event of a bus fault. ,
All
- Bus
address
interface used, the permitted address range is smaller
than the one allowed here.
- Parameter lock Prevents any parameter changes if set to On.
- Set length of I/O data
-
baudrate
-
baudrate
-
Modbus RTU network (number of data bits, parity, number
this parameter, then an autodetection function is active
-
timeout
The master has to send a telegram within the given time
otherwise the UMC triggers the configured busfault reaction.
- IP setting mode Mode how the IP address settings are made
Note: in Basic Mode the IP address is created automatically as
- IP address, octet
IP address used if connected via Ethernet communication module to
Ethernet network
- Subnet mask,
Subnet mask used if connected via Ethernet communication module
to Ethernet network
- Gateway, octet
Gateway-IP address used if connected via Ethernet communication
module to Ethernet network
- Enable
Webserver
- Retrofit
130
To Next Page
Loading...
