ABB Uvisor SF910i - Appendix I Configuration Form

Appendix I Configuration Form
In case, the SF910i is installed without making use of the serial communication lines,
photo-copies of the following form can be helpful to write down and archive the
configuration data.
Table I.1: Configuration Form
NotesConfigured ValueType Property
Burner/pilot flame identification
SF910i Serial number
Light ingress (LOS or FOC)
Spectral sensitivity (IR, UV)
Function set A:
Intensity pull-in
Intensity drop-out
Frequency pull-in
Frequency drop-out
AC-amplitude pull-in
AC-amplitude drop-out
Frequency sensitivity
Delay drop-out
Function set B:
Intensity pull-in
Intensity drop-out
Frequency pull-in
Frequency drop-out
AC-amplitude pull-in
AC-amplitude drop-out
Frequency sensitivity
Delay drop-out
Function set C:
Intensity pull-in
8VZZ005286 B 183
I Configuration Form