Nomenclatures, Part Numbers, and Related
Documentation
The below table shows a preview of the main items related to the Uvisor™ SF910i
product. For a complete list of part numbers and ordering codes (including cables,
replacement parts, and so on), refer to SF910i data sheet.
Table: Nomenclatures and Part Numbers for Most Important Items
Related DocumentPart NumberDescriptionNomenclature/Item
SF910i User Manual (this
manual)
SF910i-xx-xx-xx-xx-xx
(see Table 1.1 for the
meaning of all five suffixes)
Integrated SafeFlame
Scanner
Uvisor™ SF910i
SF910i Flame Explorer
User Manual
(8VZZ005308)
8VZZ005308Software tool for
configuration and
monitoring
Flame Explorer
See Appendix ENot a single part number.
Refer to datasheet
Line Of Sight mounting
accessories
LOS mounting accessories
See Appendix ENot a single part number.
Refer to datasheet
Fiber Optic Cable
extension and accessories
FOC mounting accessories
Compatibility with Previous ABB Flame Detection
Products
The below table shows the compatibility issues with previous products of Uvisor™,
FAU800, and DFS/SafeFlame families. The table shows, if the SF910i unit can be installed
as a replacement of the system made of previous flame scanners and Flame Analysis
Units/Multi-flame scanners.
Here it is considered as a replacement of an existing scanner plus its FAU800 or
MFD unit with the SF910i Integrated SafeFlame Scanner. Consider that it is not a
one-to-one replacement (see following note). Changes in the wiring harness are
required in this case.
SF910i Integrated SafeFlame Scanner is a “single flame unit”. If the user is planning
to replace one MFD and two flame scanners (or one FAU800 and two flame
scanners) aimed at two different flames, then the user must use two SF910i units.
For a one-to-one replacement of an existing scanner with a SF810 (conventional)
scanner, refer to SF810 User Manual.
8VZZ005286 B 17
About This User Manual
Nomenclatures, Part Numbers, and Related Documentation
To Next Page