Operation Manual / 4 Product description / A200-L
5 Operation and service / 5.2 Service work
© Copyright 2020 ABB. All rights reserved. HZTL4036_EN Rev.Q July 2020
Take note of correct customer spare part set (see chapter Ordering spare parts →102).
u Remove the filter silencer.
u Clean filter silencer and check for damage.
u Dismantle the wall insert.
u Check axial clearance A.
u Clean wall insert, diffuser and compressor casing and check for damage.
u Remove the gas inlet casing and dismantle the nozzle ring and cover ring.
u Clean the nozzle ring and cover ring and check for damage.
u Dismantle, inspect and balance the rotor.
u Replace the plain bearing
5.2.5 Service work according to instructions of enginebuilder
u Clean or replace the oil filter located in the supply pipe to the turbocharger while the en-
gine is stopped, in accordance with the instructions of the enginebuilder.
Page 26 / 110
To Next Page
Loading...
