2
79
34ZBTS_30-1200A rev.A / 1SCC303043M0201
—
8. Mounting of Accessories
More information, see animation:
Installation of accessories - TruONE™ ATS
(https://youtu.be/qV2KoIv38GY).
—
8.1 Ekip -Modules
Both switches already have a factory-in-
stalled auxiliary power supply module and
I/O signal modules Ekip Signaling 2K-1
and Ekip Signaling 2K-2.
NOTE! It is still possible to add two pieces
of Ekip modules to the switch if the
switch is a fixed version, and one Ekip-
module to the Connection Module of
draw-out switch version. Eg. if more I/O
signal modules are needed, it is possible
to add an Ekip Signaling 2K-3 and/or alter-
natively a communication module Ekip
Com module, if required.
The wiring route instruction for Ekip
-modules in the cabinet, see the Part 1,
Chapter 4.
Danger
Hazardous voltage. Only an authorised elec-
trician may perform the electrical installation
and maintenance of OX_ automatic transfer
switches. Do not attempt any installation or
maintenance actions when Bypass-isolation
automatic transfer switch is connected to the
electrical mains. Before starting work, make
sure that the switch is de-energised.
To Next Page
Loading...
