ABB Zenith ZBTS T Series - Mounting of Ekip -Modules to the Fixed Bypass Switch

2
80
Zenith ZBTS T-series 100-1200A, INSTALLATION AND OPERATING INSTRUCTION
Ekip
3
4
1
2
—
Fig. 8.1 First step: Remove carefully the factory mounted auxiliary power supply module OXEA1 and
signal modules from the fixed Bypass switch. There is no need to remove the existing wirings.
—
Fig. 8.2 Step two: Mount the Ekip –modules to the combination of auxiliary power supply module
and signal modules, then place the entire assembly back to the fixed Bypass switch.
8.1.1 Mounting of Ekip –modules to the fixed Bypass switch