ABB Zenith ZBTS T Series - Ekip Signalling 10 K

2
88
Zenith ZBTS T-series 100-1200A, INSTALLATION AND OPERATING INSTRUCTION
3
—
9.3 Ekip Signalling 10K
The Ekip Signalling 10K is an external sig-
nalling accessory module, it is factory in-
stalled only. It is mounted on the DIN rail
located on the cabinet control plate. This
Ekip signalling module provides:
• 10 contacts for output signals.
• 10 digital inputs. Input I S11 (HS21,
HS22) is not supported.
• A power LED, and 20 signalling LEDs
(one for each output/input).
The module can communicate with the
outside in two alternative ways:
• Via Local Bus, with a single trip unit
equipped with the power supply module
Ekip Supply.
• Via Link Bus, with a maximum of four
trip units each equipped with an Ekip
Link module.
Further information on Ekip Signalling
10K is available from the web site http://
www.abb.com/abblibrary/
DownloadCenter/, in particular in the
manual 1SDH001318R0002.
—
Fig. 9.5 Ekip Signalling 10K module
Notice
The module can be connected only to internal
Ethernet networks with one or more switch-
boards, to which the switch or the accessories
are connected. It is the installer's responsibil-
ity to ensure that all the necessary safety
measures are adopted for all the connected
devices (for example, the necessary access
authorisations, and so on). The module can-
not be connected to other Ethernet networks
(for example, with the purpose of monitoring
the system, or the office), or to the Internet.
In Bypass-Isolation automatic transfer
switch it is possible to use only one Ekip
Signalling 10K module (= 10K-1 configura-
tion). There is no possibility to use multi-
ple Ekip Signalling 10K modules 10K-2 and
10K-3.
NOTE! The Ekip Signalling 10K-1 is
equipped with ten inputs (with as many
LEDs, giving a total of twenty LEDs).