28
Zenith ZBTS T-series 100-1200A, INSTALLATION AND OPERATING INSTRUCTION
1
—
3.3 HMI, menu tree
Description of the Icons
Password
—
Fig. 3.3 Enter the password when asked, choose
the right number by arrowheads and confirm,
go forward entering number after number
Password
Confirm
0 ****
—
Fig. 3.4 The location of the small icons and the alarms
The default password is 00001, enter the
password when prompted (see picture
above). The default password is highly
recommended to be changed.
The small icons in Switch Overview -pages
are:
On upper right corner
Indicates the amount of pages
and the page where you are at
the moment
Auxiliary voltage connected
11:06 Time
Application set up as Transformer-
Generator. Generator start-up
signal deactivated
Application set up as Transformer-
Generator. Generator start-up
signal activated
*E* Indicates that generator exerciser
is programmed.
On upper left corner
60s Time delay, in Alarm list you can
see the name of delay at the same
time, e.g. Generator stop delay
On middle area
S1 p Letter "p" after S1 indicates that
S1 is a priority source
Software button which allows
skipping ongoing time delay.
Visible when any skippable delay
is ongoing
Bypass
Delay
11:0660s
Switch Overview
S1 p Ok Not Ok S2
S1 Connected to Load
Bypass Connected
Load Current
393 A
Generator stop delay
TruONE ATS
*E*
Bypass
Delay
G
To Next Page
Loading...
