ABB Zenith ZBTS T Series - Mounting of the Ekip -Modules to the Draw-Out Switches

2
81
34ZBTS_30-1200A rev.A / 1SCC303043M0201
8.1.2 Mounting of the Ekip –modules to the draw-out switches
Ekip
Ekip
—
Fig. 8.3 First step: Remove carefully the factory mounted Ekip power supply module and signal modules
from the draw-out switch Connection Module. There is no need to remove the existing wirings.
—
Fig. 8.4 Step two: Mount the Ekip –module to the combination of Ekip power supply module and signal
modules, then place the entire assembly back to the draw-out switch Connection Module.
Ekip