18
Program Play
By using the program function, the tracks on a disc can be played in any desired sequence. The maximum memory
capacity is 32 tracks (or a total playing time of 999 minutes 59 seconds).
1
In the stop mode, press the
PROGRAM
button.
●
The "PROGRAM" indicator lights up and the unit is ready for program input.
●
Program input is also possible during playback or in the pause mode, but the
programming progress is not shown.
2
Use the direct play buttons to enter track numbers in the desired sequence into memory.
The selected track number along with the current program number and the accumu-
lated playing time are shown on the display.
●
If you have made a mistake, press the
CLEAR
button and enter the correct track
number.
●
For track numbers 11 and higher, use the
＞10
button (see page 14).
3
When the program has been input, press the
PLAY
button.
Playback starts in the programmed sequence.
Before or during playback, you can use the
CHECK
button to verify the program
contents. With each push of the button, the programmed track numbers and the total
playing time to that point are shown in sequence. During playback, only programmed
tracks that have not yet been played are shown.
If the button is not pushed for two seconds, the display reverts to its original condition.
※When the end of the program is reached, the indication
appears.
Programming steps
To return to normal playback
Press the
CONTINUE
button.
To check the program sequence and number of tracks
Track number
Program number
Total programmed
playing time
SACD
SECTRACK INDEX
MIN
MODEL RC-28
CLEAR
PROGRA
PLAY
1
4
7
2
5
8
3
6
9
10/0
＞10
Direct play buttons
MODEL RC-28
CONTINUE CHEC
To Next Page
Loading...
Need help?
Optical Specifications
Power
Weight and Dimensions
