Machine Maintenance Procedures 3-35
Microphone Board Removal 0
Prerequisite:
LCD Bezel Removal
1. Find the microphone board (A) on the LCD cover. Refer to Figure 3-37.
2. Peel back the tape (B) securing the microphone cable (C) to the microphone board
(A) (Figure 3-40).
3. Disconnect the microphone cable (C) from the connector (Figure 3-40).
Use care not to damage the cable.
Figure 3-40. Microphone Connector Location
4. Gently lift and remove the microphone board (A) from the LCD cover (Figure 3-41).
Figure 3-41. Microphone Board Removal
To Next Page
Loading...
