Machine Maintenance Procedures 3-45
LCD Module Reassembly Process 0
Replacing the WLAN Antenna 0
1. Place the AUX antenna (white-color) to the left and the MAIN antenna (black-color)
to the right on the LCD cover. Make sure that the edge of the antenna PCB is
properly seated and placed onto its compartment highlighted by a green rectangle as
shown in Figure 3-55.
2. Adhere the MAIN antenna and AUX antenna grounding foils in place (Figure 3-55).
Figure 3-55. Replacing the WLAN Antenna
3. Route and secure the WLAN antenna cables to the cable guides (Figure 3-56).
Figure 3-56. Replacing the WLAN Antenna
To Next Page
Loading...
