Machine Maintenance Procedures 3-47
Replacing the WWAN Antenna (For C732L & C732LT only) 0
1. Place the MAIN antenna (yellow-color) to the right on the LCD cover. Make sure that
the edge of the antenna PCB is properly seated and placed onto its compartment
highlighted by a green rectangle as shown in Figure 3-58.
2. Adhere the MAIN antenna grounding foil in place (Figure 3-58).
Figure 3-58. Replacing the WWAN MAIN Antenna
3. Place the AUX antenna (blue-color) to the left on the LCD cover. Make sure that the
edge of the antenna PCB is properly seated and placed onto its compartment
highlighted by a green rectangle as shown in Figure 3-59.
4. Adhere the AUX antenna grounding foil in place, and route the AUX antenna cable
to the cable guides (Figure 3-59).
Figure 3-59. Replacing the WWAN AUX Antenna
To Next Page
Loading...
