3-64 Machine Maintenance Procedures
Replacing the Touchpad Module 0
1. Place the touchpad module into its compartment on the top assembly. Make sure
that the bottom edge of the touchpad bracket are secured onto the two latches on
the top assembly (Figure 3-81).
2. Install and secure four (4) screws (G) to the touchpad module (Figure 3-81).
Figure 3-81. Replacing the Touchpad Module
3. Flip the keyboard plate mylar (F) over the touchpad module (D) (Figure 3-82).
4. Connect the TP end of the touchpad FPC (E) to the touchpad module connector (C)
and connect the MB end to the mainboard connector (B) (Figure 3-82).
Figure 3-82. Replacing the Touchpad Module
To Next Page
Loading...
