System Utilities 2-19
Run RMA Shim 0
1. Plug in the AC adapter then open the lid (LCD panel) to turn on the system.
DO NOT unplug the AC adapter.
2. The system will restart automatically when the RMA image installation is complete
and then automatically boot to Factory Test mode (This process may take about 30-60
seconds).
Figure 2-33. Factory Test Mode (1 of 2)
Figure 2-34. Factory Test Mode (2 of 2)
3. Make sure the USB RMA drive is removed from the system, and then start the RMA
and Factory Tests.
To Next Page
Loading...
